Lightning Counter Testing Instrument
Darui Electric recommends:
Features:
1, Lightning Counter Tester Please charge before use,To ensure charging effect and extend battery life, use the dedicated charger. It takes about 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging.
2. According to the installation height of the counter, properly extend the telescopic discharge rod.
3. For the dedicated grounding wire, insert one end plug into the jack at the rear of the calibrator, and clamp the other end to the ground.
4. Press the red button to connect high voltage for about 1 second, the indicator light will turn on (flicker slightly), then gently tap the connection end between the counter and the lightning arrester for testing.
5. After each tap, the tip of the discharge rod should leave the counter. If repeated testing is needed, do not release the button. Wait for 1-2 seconds until the indicator light flickers again, then tap again for testing.
6. Continuous testing will cause the calibrator to heat up. Please pay attention to appropriate intervals to reduce faults and extend battery life.
7. The calibrator output has three levels: high, medium, and low, which can be adjusted through the toggle switch at the head to adapt to testing different types or brands of counters.
8. If the indicator light does not flicker after pressing the button for more than 3 seconds, it indicates that the battery needs charging.
9. Do not disassemble the calibrator arbitrarily.
Instructions:
1. Please charge before use. To ensure charging effect and extend battery life, use the dedicated charger. It takes about 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging; the green light indicates charging is complete.
2. According to the installation height of the counter, properly extend the telescopic discharge rod.
3. For the dedicated grounding wire, insert one end plug into the jack at the rear of the calibrator, and clamp the other end to the ground.
4. Press the red button to connect high voltage for about 1 second, the indicator light will turn on (flicker slightly),
then gently tap the connection end between the counter and the lightning arrester for testing.
5. After each tap, the tip of the discharge rod should leave the counter. If repeated testing is needed, do not release the button. Wait for 1-2 seconds until the indicator light flickers again, then tap again for testing.
6. Continuous testing will cause the calibrator to heat up. Please pay attention to appropriate intervals to reduce faults and extend battery life.
7. The calibrator output has three levels: high, medium, and low, which can be adjusted through the toggle switch at the head to adapt to testing different types or brands of counters.
8. If the indicator light does not flicker after pressing the button for more than 3 seconds, it indicates that the battery needs charging.
9. Do not disassemble the calibrator arbitrarily. If the battery capacity drops significantly or the charging efficiency is too low, it needs to be replaced.
Note: The above information and technical parameters are compiled and released by Yangzhou Darui Electric Co., Ltd.
