Rod Type Discharge Counter Tester
Dary Electric recommends:
Overview of Rod Type Discharge Counter Tester:
1. Voltage: DC 900V, 1200V, 1600V three gears
2. Discharge current >100A/10US
II. Usage Method
.1. Charge before use. To ensure charging effect and prolong battery life, use the dedicated charger. It takes 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging; green light indicates charging is complete. Before use, connect the attached ground wire plug at the tail end, and connect the ground clip to the earth.
2. According to the installation height of the counter, appropriately extend the telescopic discharge rod.
3. Press the red button to turn on high voltage for about 1 second. When the indicator light is on (flickering), gently tap the connection end between the counter and the arrester for testing.
4. After each tap, the discharge rod tip should be removed from the counter. If repeated testing is needed, you may keep the button pressed. After about 1-2 seconds, when the indicator light flickers again, you can tap again for testing.
5. Continuous testing will cause the tester to heat up. Please allow appropriate intervals.
6. If the indicator light does not flicker after pressing the button for more than 3 seconds, it indicates that the battery needs charging.
7. Do not disassemble the tester arbitrarily. If the battery capacity drops significantly or charging efficiency is too low, replacement is needed. Please purchase the dedicated battery pack from our company.
