800~1000V Lightning Counter Tester Quotation - Yangzhou Darui

Published: 2024-07-01 12:36:28

Category: Lightning Counter Calibrator

Product Description

800~1000V Lightning Counter Tester Quotation

Darui Electric recommends:

Instructions

1. Please charge before use. To ensure charging effectiveness and extend battery life, use the dedicated charger. It takes about 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging; the green light indicates charging is complete.

2. According to the installation height of the counter, appropriately extend the telescopic discharge rod.

3. For the dedicated grounding wire, insert one end plug into the tail socket of the tester, and clamp the other end to the ground.

4. Press the red button to turn on high voltage for about 1 second. When the indicator light turns on (flickers slightly), gently tap the connection end between the counter and the arrester for testing.

5. After each tap, the discharge rod tip should be removed from the counter. If repeated testing is needed, do not release the button. Wait 1-2 seconds until the indicator light flickers again, then tap again for testing.

6. Continuous testing may cause the tester to heat up. Please allow appropriate intervals to reduce malfunctions and extend battery life.

7. The tester output has three levels: high, medium, and low, adjustable via the toggle switch on the head to accommodate testing of different types or brands of counters.

8. If the indicator light does not flicker after pressing the button for more than 3 seconds, the battery needs charging.

9. Do not disassemble the tester arbitrarily. If the battery capacity significantly decreases or charging efficiency is too low, replace it.

800~1000V Lightning Counter Tester Quotation User Guide:

The power switch is located between the body and the head. Rotate it 90 degrees in any direction; hearing a "click" indicates the power is on, and the opposite indicates off. Before use, insert the grounding wire into the tail socket. After turning on the power, the green light will turn on. When the red light turns on (about 3-5 seconds), you can test the lightning counter through the head's telescopic conductive rod (which can be pulled out before powering on according to the counter's installation height). You can test repeatedly without turning off the power (the conductive rod should be removed from the test object each time charging).

← Previous
800~1000V Lightning Counter Tester - Yangzhou Dary Next →
Factory Supply 800~1000V Lightning Counter Tester - Yangzhou Darui

Product Details