How to Use Lightning Counter Calibrator
Dary Electric recommends for you;
Technical Parameters:
1. Voltage: DC 900V 1200V 1600V three gears
2. Discharge current>100A/10US
3. Weight: 420g
4. Length: 450cm
5. Test interval time: 1 second
6. Test times: 300 times
7. Charging: 3~4 hours
Instructions:
1. Please charge the lightning counter calibrator before use. To ensure charging effect and extend battery life, the lightning counter calibrator must use the dedicated charger. It takes about 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging; the green light indicates charging is complete.
2. According to the installation height of the counter, properly extend the telescopic discharge rod.
3. For the dedicated grounding wire, insert one end plug into the jack at the rear of the calibrator, and connect the other end clip to the ground.
4. Press the red button to turn on high voltage for about 1 second, the indicator light will light up (flicker slightly),
then gently click the connection end between the counter and the arrester for testing.
5. After each click, the discharge rod tip should leave the counter. If repeated testing is needed, do not release the button. Wait 1-2 seconds until the indicator light flickers again, then click to test again.
6. Continuous testing may cause the calibrator to heat up. Please allow appropriate intervals to reduce failures and extend battery life.
7. The calibrator output has three gears: high, medium, and low, which can be adjusted via the toggle switch on the head to adapt to testing different types or brands of counters.
8. If the indicator light does not flash after pressing the button for more than 3 seconds, it indicates that the battery needs charging.
9. Do not disassemble the calibrator arbitrarily. If the battery pack capacity drops significantly or charging efficiency is too low, it needs to be replaced. Please purchase a dedicated battery pack from our company.
Product Features:
1. Portable design, small size and light weight
2. Telescopic electrode can adjust length according to height
3. AC/DC dual power supply, built-in rechargeable battery, one charge can last for half a year
4. Strong anti-interference capability
5. Maximum voltage 1500V
Note: The above information and technical parameters are compiled and released by Yangzhou Dary Electric Co., Ltd.
