Manufacturer Rental and Sale of Smart HY Lightning Arrester Counter Tester 

Features of Manufacturer Rental and Sale of Smart HY Lightning Arrester Counter Tester

1. Please charge before use. To ensure charging effectiveness and extend battery life, use the dedicated charger. It takes about 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging is in progress.

2. According to the installation height of the counter, properly extend the telescopic discharge rod.

3. For the dedicated grounding wire, insert one end's plug into the jack at the rear of the tester, and clip the other end's clamp to the ground.

4. Press the red button to turn on high voltage for about 1 second. The indicator light will illuminate (with a slight flicker). Then gently touch the connection end between the counter and the arrester for testing.

5. After each touch, the tip of the discharge rod should be removed from the counter. If repeated testing is needed, do not release the button. Wait for 1-2 seconds until the indicator light flickers again, then touch again for testing.

6. Continuous testing may cause the tester to heat up. Please allow appropriate intervals to reduce malfunctions and extend battery life.

7. The tester output has three levels: high, medium, and low, which can be adjusted via the toggle switch on the head to accommodate different types or brands of counters.

8. If the indicator light does not flicker after pressing the button for more than 3 seconds, the battery needs to be charged.

9. Do not disassemble the tester arbitrarily. If the battery pack capacity significantly decreases or charging efficiency is too low, it needs to be replaced. Please purchase a dedicated battery pack from our factory.