DARUI Electric recommends:
HY-DC6V Lightning Counter Tester User Guide:
The power switch is located between the body and the head. Rotate it 90 degrees in any direction; hearing a "click" indicates the power is on, otherwise it is off. Before use, insert the grounding wire at the tail. After powering on, the green light will illuminate, and when the red light turns on (about 3-5 seconds), you can test the lightning counter by extending the telescopic conductive rod from the head (which can be pulled out before powering on according to the counter's installation height). You can test repeatedly without turning off the power (the conductive rod should be away from the test object during each charging).
Usage Instructions:
.1. Charge before first use. To ensure charging effectiveness and extend battery life, use the dedicated charger. It takes 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging; the green light indicates charging is complete. Before use, plug in the attached ground wire plug at the tail, and connect the ground clip to the earth.
2. According to the counter's installation height, appropriately extend the telescopic discharge rod.
3. Press the red button to activate high voltage for about 1 second. When the indicator light flashes (slightly), gently tap the connection terminal between the counter and the arrester for testing.
4. After each tap, the discharge rod tip should be removed from the counter. If repeated testing is needed, you don't have to release the button. After about 1-2 seconds, when the indicator light flashes again, you can tap again for testing.
5. Continuous testing may cause the tester to heat up; please allow appropriate intervals.
6. If the indicator light does not flash after pressing the button for more than 3 seconds, the battery needs charging.
7. Do not disassemble the tester arbitrarily. If the battery capacity significantly drops or charging efficiency is too low, it needs replacement. Please purchase the dedicated battery pack from our company.
Note: When the indicator light is on (slightly flashing), no part of the body should touch the electrode parts, otherwise there is a risk of electric shock.
Note: The above information and technical parameters are compiled and released by Yangzhou DARUI Electric Co., Ltd.
