Darui Electric recommends for you:
The Lightning Counter Calibrator instrument has a beautiful appearance and is easy to carry and use. It replaces the traditional bulky testing instruments and methods, and is highly welcomed by professionals.
1. Technical Parameters
1. Voltage: DC 900V, 1200V, 1600V three gears
2. Discharge current >100A/10US 2. Usage method.
1. Charge before use. To ensure charging effect and extend battery life, use the dedicated charger. It takes 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging; the green light indicates charging is complete. Before use, plug in the attached ground wire plug at the tail end, and connect the ground clip to the earth. 2. According to the installation height of the counter, appropriately extend the telescopic discharge rod.
3. Press the red button to turn on high voltage for about 1 second. The indicator light will be on (slight flicker), then you can gently click the connection end of the counter and the arrester for testing.
4. After each click, the discharge rod tip should leave the counter. If repeated testing is needed, you do not need to release the button. After about 1-2 seconds, when the indicator light flickers again, you can click again for testing.
5. Continuous testing may cause the tester to heat up. Please pay attention to appropriate intervals.
6. If the indicator light does not flicker after pressing the button for more than 3 seconds, it indicates that the battery needs charging.
7. Do not disassemble the calibrator at will. If the battery capacity drops significantly or the charging efficiency is too low, it needs to be replaced. Please purchase the dedicated battery pack from our company. Note: When the indicator light is on (slight flicker), no part of the body should touch the electrode part, otherwise there is a risk of electric shock.
Note: The above information and technical parameters are compiled and released by Yangzhou Darui Electric Co., Ltd.
