Desktop|中文
Home About Us Products + News Center Technical Articles Messages Contact Us

Product Details

全自动Dielectric Loss Tester-扬州达瑞

Lightning Counter Tester - Yangzhou Darui

Published: 2024-07-01 12:36:18

Views: 2922

Category: Lightning Counter Calibrator

Product Description


Lightning Counter Tester 

Darui Electric recommends:

Lightning Counter Tester Technical Parameters:



1. Voltage: DC 900V, 1200V, 1600V three gears

2. Discharge current >100A/10US

3. Weight: 420g

4. Length: 450cm

5. Test interval time: 1 second

6. Test times: 300 times

7. Charging: 3~4 hours



Lightning Counter Tester Product Features:

1. Portable design, small size and light weight

2. Telescopic electrode can be adjusted in height and length

3. AC/DC dual power supply, built-in rechargeable battery, one charge can last for half a year

4. Strong anti-interference ability

5. Maximum voltage 1500V



Instructions:



1. Please charge before use. To ensure charging effect and extend battery life, use the dedicated charger. It takes about 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging; the green light indicates charging is complete.

2. According to the installation height of the counter, properly extend the telescopic discharge rod.

3. For the dedicated grounding wire, insert one end plug into the jack at the rear of the calibrator, and clamp the other end to the earth.

4. Press the red button to turn on high voltage for about 1 second. The indicator light will light up (flicker slightly), then gently click the connection end of the counter and lightning arrester for testing.

5. After each click, the discharge rod tip should be removed from the counter. If repeated testing is needed, do not release the button. Wait 1-2 seconds until the indicator light flickers again, then click again for testing.

6. Continuous testing will cause the calibrator to heat up. Please pay attention to appropriate intervals to reduce failures and extend battery life.

7. The output has three gears: high, medium, and low, which can be adjusted through the toggle switch on the head to adapt to testing different types or brands of counters.

8. If the indicator light does not flash after pressing the button for more than 3 seconds, it indicates that the battery needs charging.

9. Do not disassemble the calibrator arbitrarily. If the battery pack capacity drops significantly or charging efficiency is too low, it needs to be replaced.




Note: The above information and technical parameters are compiled and released by Yangzhou Darui Electric Co., Ltd.

WeChat QR Code
💬
💬 Message

Hello! Have you found what you need? Contact us directly online!

Leave a Message for Consultation
Yangzhou Darui Electric Co., Ltd.
主营产品:Dielectric Loss Tester、Transformer Ratio测试仪、Loop Resistance Tester、高压None线核相仪、Insulation Resistance Tester、Partial Discharge Tester、Cable Fault Tester、DC Resistance Tester等。
☎ Phone: 18952707000(关经理)📞 Landline: 0514-88770377✉ Email: 195214804@qq.com
Verification Code
By submitting, you agree to ourTerms of ServiceandPrivacy Policy
🏠 网站Home📞 一键拨号✉ Contact Us