Desktop|中文
Home About Us Products + News Center Technical Articles Messages Contact Us

Product Details

全自动Dielectric Loss Tester-扬州达瑞

FZY-3 Stray Current Tester - Yangzhou Darui

Published: 2024-07-01 12:42:05

Views: 2922

Category: Mining Stray Current Tester

Product Description
FZY-3 Stray Current Tester 

Darui Electric recommends:


Instructions and precautions for using the FZY-3 Stray Current Tester:

1. Before measurement, screw the test rod wires onto the two binding posts respectively, and adjust the meter pointer to the zero scale line.

2. Place the test rods connected to the binding posts on the two points to be measured (e.g., rails, water pipes, cable sheaths, coal, ground, etc.). The two test points should be on different conductors, with a distance of about 2 meters. Normally, measure every 50-100 meters, or temporarily determine test points as needed. Set the selector switch to the appropriate range, and the meter reading, after conversion, gives the corresponding current value.

3. During measurement, ensure good contact between the hard alloy tip of the measuring probe and the object under test. The meter should be placed horizontally to ensure accurate readings.

4. If AC stray current is not detected at a location, also test for DC stray current, and vice versa.

5. When measuring stray voltage values, the ranges correspond as follows: 50mA corresponds to 0.2V, 250mA to 1V, 1A to 4V, 5A to 20V, and 10A to 40V. (That is, the current value multiplied by 4 gives the voltage value.)

6. When the magnitude of stray current is unknown, first set to the maximum range, then gradually decrease until the appropriate measuring range is reached.

7. When the measured current exceeds 5A, the instrument should only be used for short-term measurements. When the measured current exceeds 10A, the instrument should only be used for instantaneous measurements to avoid burning out components and the meter.


WeChat QR Code
💬
💬 Message

Hello! Have you found what you need? Contact us directly online!

Leave a Message for Consultation
Yangzhou Darui Electric Co., Ltd.
主营产品:Dielectric Loss Tester、Transformer Ratio测试仪、Loop Resistance Tester、高压None线核相仪、Insulation Resistance Tester、Partial Discharge Tester、Cable Fault Tester、DC Resistance Tester等。
☎ Phone: 18952707000(关经理)📞 Landline: 0514-88770377✉ Email: 195214804@qq.com
Verification Code
By submitting, you agree to ourTerms of ServiceandPrivacy Policy
🏠 网站Home📞 一键拨号✉ Contact Us