Lightning Counter Calibrator - Yangzhou Darui - Yangzhou Darui Electric Co., Ltd.

Lightning Counter Calibrator - Yangzhou Darui

Published: 2024-07-01 12:36:15

Category: Lightning Counter Calibrator

Product Description

Lightning Counter Calibrator

Darui Electric recommends:

The Lightning Counter Calibrator is designed and developed according to the needs of power users. It has a beautiful appearance and is convenient to carry and use. It is designed and developed according to the needs of power users. It has a beautiful appearance and is convenient to carry and use.

Features

1. Please charge before use. To ensure charging effect and extend battery life, use the dedicated charger. It takes about 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging.

2. According to the installation height of the counter, properly extend the telescopic discharge rod.

3. For the dedicated grounding wire, insert one end plug into the jack at the rear of the calibrator, and connect the other end clip to the ground.

4. Press the red button to turn on high voltage for about 1 second. The indicator light will light up (flicker slightly), then gently click the connection end between the counter and the arrester for testing.

5. After each click, the discharge rod tip should leave the counter. If repeated testing is needed, do not release the button. Wait for 1-2 seconds until the indicator light flickers again, then click again for testing.

6. Continuous testing will cause the calibrator to heat up. Please pay attention to appropriate intervals to reduce failures and extend battery life.

7. The calibrator output has three levels: high, medium, and low, which can be adjusted through the toggle switch on the head to adapt to testing different types or brands of counters.

8. If the indicator light does not flicker after pressing the button for more than 3 seconds, it indicates that the battery needs charging.

9. Do not disassemble the calibrator arbitrarily.

Detailed Introduction

1. Portable design, small size and light weight

2. Telescopic electrode can adjust length high and low

3. AC/DC dual power supply, built-in rechargeable battery, one charge can be used for half a year

4. Strong anti-interference ability

5. Maximum voltage 1500V

Technical Parameters

1. Voltage: DC 900V 1200V 1600V three levels

2. Discharge current >100A/10US

3. Weight: 420g

4. Length: 450cm

5. Test interval time: 1 second

6. Test times: 300 times

7. Charging: 3~4 hours

Note: The above information and technical parameters are compiled and released by Yangzhou Darui Electric Co., Ltd.

← Previous
LBQ-II Leakage Protector Tester - Yangzhou Darui None

Product Details